Using a wireless network
Setting up the FortiWiFi-60 as an Access Point
FortiWiFi-60 Installation Guide
01-28008-0030-20050128
39
5
Enter a key or pre-shared key depending on the Security Mode selected.
6
Select the MAC Filter tab.
7
Enable MAC filtering if desired.
8
Enter the MAC addresses and select to Add or Deny them from the wireless network.
Configure the firewall policies
The FortiWiFi-60 unit provides WAN interfaces for Internet connections. You can
configure the Internet connection for both wired networks on the internal and/or DMZ
interfaces and the wireless network through the WLAN interface.
You can provide secure Internet access for wireless clients by creating firewall
policies from the WLAN interface to the WAN1 or WAN2 interfaces.
The following example creates a policy from the wireless clients (WLAN interface) to
the Internet (WAN1 interface) using traffic shaping, firewall authentication and the
default Strict content policy.
To create a new wall policy for a secure Internet connection
1
Go to
Firewall > Policy
.
2
Select the blue arrow for WLAN to WAN1.
3
Select Create New.
Configure the following settings:
4
Select Advanced.
5
Select Authentication.
6
Type the user name or group name.
7
Select Traffic Shaping
8
Configure traffic shaping bandwidth and Traffic Priority settings to meet your
requirements.
9
Select OK.
Note:
You will need to distribute the information entered in step 2 and step 5 with the wireless
users so they can connect to the wireless network.
Interface/Zone Source
WLAN
Interface/Zone
Destination
WAN1
Address Name Source
All
Address Name
Destination
All
Schedule
Always
Service
ANY
Action
ACCEPT
NAT
Enable
Protection Profile
Strict