Wall Mounting
Installing the FON-450i/FON-550i
8
FON-450i and FON-550i Telephones Start Guide v2
Wall Mounting
The FON-450i/FON-550i phone supports wall mounting via the base of the
phone housing. Wall mount the FON-450i/FON-550i using the instructions
below in Figure 4.
•
Mark and drill two 7 mm (5/16”) holes for plastic wall anchors (not
included) with a vertical separation of 10 cm (4”).
•
Insert two anchors into the holes, then insert and tighten the two screws
(not included) leaving about 2.5 mm (1/8”) exposed.
•
Attach all wiring to the phone.
•
Slide the phone over the screws and ensure the phone is secure. Note it
may be necessary to remove the phone and tighten or loosen the screws
for secure mounting. Also note, the stand must not be attached to the
phone when mounting on a wall.
•
Remove the handset hook from the phone as shown in the figure below.
Reverse the hook and re-install in the phone so that the hook catches the
groove in the handset receiver.
•
Complete all wiring.
Figure 4: FON-450i/FON-550i Wall Mount Installation
Summary of Contents for FortiFone FON-450i
Page 1: ...FON 450i and FON 550i Telephones Start Guide...
Page 33: ...www fortinet com...
