Settings Overview
Page 9
FortiFone User Guide
STUN
The
STUN
settings of the phone include:
•
Server address
— enter the given server address.
•
Server port
— default port is 3478.
•
Local SIP Port
—default port is 5060.
802.1x
You can enable and modify the following 802.1x settings:
•
802.1x Mode
— contains the following options:
— Off
— EAP-MD5
— EAP-TLS
— PEAP-MSCHAPV2
• Identity
• Password
Accounts
Global
The
Global
section contains advanced SIP settings that affect all accounts.
•
Strict Branch
— if enabled, the value of the branch must be after “z9hG4bK” in the
VIA
field
of a received INVITE message, or the phone will not respond to INVITE message.
•
Enable Group
— enables SIP Group Backup.
•
Enable RFC4475
— if enabled the phone will support RFC4475, used for testing purposes.
•
Registration Failure Retry Time
— if registration should fail, the phone will try to register
again within the specified amount of seconds.
•
Enable Strict UA Match
— if enabled, the Request url of a received INVITE must match the
Server Address of the Account settings.
Account 1-6
The phone can be configured with up to 6 separate accounts manually. Each account contains
the same configuration options. Only one account is needed to operate with the FortiVoice and
will be automatically configured by the FortiVoice
.
To configure the phone manually outside of use with FortiVoice, tap on which account you
would like to configure and enter the password as
123456
. The following settings are available:
•
Enable registration
— this must be enabled in order for the phone to register with these
account settings.
•
Server address
— enter the address of the SIP server.
These settings do not need to be adjusted when the phone is being used with a FortiVoice.
Configuration of these settings outside of the FortiVoice is not supported.