9
Install the Hub Cover by
aligning it with the hub centre
axis and turning it clockwise.
Holding gently the lamp arm, take
a glass shade and install it over the
bulb turning it clockwise. Tighten.
Install the other 11 glass shades.
Holding gently the lamp
arm, take a bulb and
install it turning it
clockwise. Do the same
for the bottom socket.
Tighten them. Repeat
for the other 5 arms.
Installing the Blades
Installing Hub Cover and Lights
Insert Blade in the side slot in the Motor Assembly.
Be sure that the blade part marked “This Side Up” is
towards the ceiling.
Take 3 Blade Screws from Pack of screws (11) and
pre-install the Plastic Blade Washers on them.
Align blade arm screw holes with 3 holes in the
motor hub on the lower part of the Motor Assembly.
Insert the 3 Blade Screws with Blade Washers and
tighten them securely with a Philips screwdriver.
Check that the 3 screws are tight.
HAND TIGHTEN ONLY. DO NOT USE A POWER
TOOL TO TIGHTEN BLADE SCREWS.
Rotate the secure blade and repeat the process for
the remaining Blades.
