Set Screw
and Nut
Set Screw
Clamp
Yoke
Installing the Down Rod
Securing Fan to Bracket
7
1. Remove the Clip (7)
and Pin (8) from your
Down Rod (6). Save
the clip and the pin.
4. Thread the wires and
Safety Cable that
comes from the motor
assembly through the
Down Rod.
2. Insert the Canopy (5)
and the Yoke Cover
(9) following the
drawing on the right.
Put this assembly
aside.
5. Insert the Down Rod into
the Yoke making sure that
the wires are not twisted
and aligning the holes for
the pin on the Down Rod
with the holes in the motor
Yoke. Insert Pin all the way
through and put the Clip in
place. Secure tightly
the 2
Set Screws and Nut. Lower
Yoke cover until it rests on
the Motor Assembly.
1. Using a step ladder lift the fan and using the
opening in the bracket, insert the hanging ball
part of the Down Rod into the bracket and let it
rest there. Gently turn the Down Rod until
you see and feel that the ball slot engages
firmly with the hanging Bracket tab.
2. Find a secure place (preferably a joist) and
using a wood screw and washer (not supplied)
secure the safety cable to it. Adjust the slack of
the safety cable using the clamp. (This step is
NOT required in the US, you can cut the safety
cable or just coil it around the canopy).
3. Loosen the Set Screw
and Nut and the Set
Screw on the Yoke.
Take the Clamp out
from the Safety
Cable.
Down Rod
Clip Pin
Canopy
Yoke Cover
Wood Screw
and Washer
Clamp
Safety Cable
Wood Ceiling Joist
Safety Cable Loop
Hanging Bracket Tab
Hanging Ball Slot
!
WARNING: Failure to align
hanging ball slot with hanging bracket
tab may result in serious personal
injury or death.
