5. Dome/Vent Assembly
Overview
The Artigiano dome is delivered as a single piece, with
four handles. The Artigiano vent is a separate vent
component, and can be installed either on brick supporting
walls, and attached to the enclosure wall.
Instructions
Place the Artigiano dome “around” the oven floor, taking
care to not chip or crack the floor pieces. Before lifting and
placing the dome, set the front floor piece roughly 6” (15
cm) backward, overlapping with the rear floor pieces. This
will help you position the oven dome without having to
worry about hitting the oven floor.
With the help of 3-4 strong men, lift the Artigiano by the
handles, and set it on the oven hearth. Reposition the front
floor piece, taking care to make sure that it is flush and
level.
5.1. Artigiano handles ready to get set in place.
5.2. Artigiano centered on FB Board.
Depending on your enclosure design and overall design
goals, the vent can be attached either to the enclosure
walls using metal studs, or it can be attached to brick vent
walls. Both work equally well, and it is up to the builder or
designer to make decide which method works for each
installation.
5.3. Artigiano vent attached to metal stud frame.
Artigiano Installation and Operating Manual
© Forno Bravo, LLC 2008/9. All Rights Served.
Ver. 2.2
23
