Forney 190 MIG, Owner'S Manual

Page: 10 / 24

10 WWW.FORNEYIND.COM
Notes:
• Periodically inspect supply cable for any cracks or exposed wires. If it is not in good condition,
have it repaired by a Service Center.
• Do not pull violently the input power cable to disconnect it from supply outlet.
• Do not lay material or tools on the power supply cable. The cable may be damaged and result
in electrical shock.
• Keep the supply cable away from heat sources, oils, solvents or sharp edges.
• If you use an extension cord, keep it as straight as possible. For lengths up to 50 ft. use 12
AWG. For lengths up to 100 ft. use 10 AWG.
For your safety, before connecting the power source to the line, closely follow these instructions:
• An adequate two-pole switch must be inserted before the main outlet. This switch must be
equipped with time-delay fuses.
• The connection with ground must be made with a two-pole plug compatible with the above
mentioned socket.
• When working in a confined space, the welder must be kept outside the welding area and the
ground cable should be fixed to the workpiece. Never work in a damp or wet confined space.
• Do not use damaged input or welding cables.
• The welding torch should never be pointed at the operator’s or at other persons’ bodies.
• The welder must never be operated without its panels attached. This could cause serious injury
to the operator and could damage the equipment.
California Proposition 65 Warnings
Welding or cutting equipment and processes produce fumes or gases which contain chemicals
known to the State of California to cause birth defects and, in some cases, cancer. (California
Health & Safety Code Section 25249.5 et seq.)
Safety Instructions