T 1.800.451.0410 | F 412.781.7840 | www.forms-surfaces.com
page 4 of 7 | 10-16-17
LEVELe
®
ELEVATOR INTERIORS WITH LIGHTPLANE
INSTALLATION INSTRUCTIONS
© 2017 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
Repeat steps 8-10 as required.
•
No side Panel Clips are installed for last panel
of row.
•
At any point where two panels meet, Panel
Clips should cross over both panels, as
seen above, to ensure ideal panel alignment.
15
Install Handrail Panel.
•
Configurations with a handrail panel come
with handrails factory installed on a single
panel.
•
For configurations in which handrails must
span multiple panels, shoulder bolts will be
installed. Once all panels are installed, slide
handrail onto shoulder bolts and tighten
underside set screws with provided allen key.
16
17
18
REAR
SIDE
REAR
SIDE
Install top Panel Clips.
•
Attach the clips as shown, using the provided
self-drilling screws.
•
One panel clip should be installed every 18-
24" for proper alignment.
REAR
SIDE
REAR
SIDE
Continue to Install Panels in sequence.
•
Rest the first upper panel on the Panel Clips
to position the first upper panel over the
Handrail Panel. Refer to step 8 for detail.
Panel 1
Panel Clip
Panel 2
Installed
Panel
Panel Clip
SIDE VIEW
14
REAR
SIDE
Install next Panel in sequence.
•
Using the installation sequence document
provided with your elevator interiors, install
panels in the order indicated using the
method described in steps 8-10.
•
Panels must engage fully with Hanging
Clips and Panel Clips.
•
Debris in the Hanging Clips, Mounting
Extrusion or Panel Clips will prevent the
panel from engaging fully.
13
Attach lead to elevator interior wall.
•
Attach the lead(s) to the wall with masking
tape.
•
There will be enough lead for the quick
connect to reach the cab shell ceiling. The
lead will run through the milled slot in the
frame.
