T 1.800.451.0410 | F 412.781.7840 | www.forms-surfaces.com
page 3 of 7 | 10-16-17
LEVELe
®
ELEVATOR INTERIORS WITH LIGHTPLANE
INSTALLATION INSTRUCTIONS
© 2017 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
Install (1) Mounting Extrusion
•
Align Mounting Extrusion vertically with
the endpoint. Use the provided 1" spacer
above the Base Support to set the
Mounting Extrusion at the proper height.
•
Be sure the mounting extrusion is square
relative to the base.
•
Attach using provided self-drilling screws.
•
Install (1) Mounting Extrusion per side
wall. If LightPlane Panels are adjacent
to Mounting Extrusion, the extrusion will
need to be cut to avoid damage to the
exit wire(s).
7
8
Install 1st Panel.
•
Remove debris from Mounting Extrusion
and Base Cleat with a brush prior to
installation.
•
The first panel will engage into the vertical
Mounting Extrusion and Base Cleat.
•
It is important that lower panels are
installed straight and level, and engage
fully with the mounting extrusion.
9
Attach side Panel Clips.
•
Attach the clips as shown, using the provided
self-drilling screws.
•
One panel clip should be installed every
18-24" for proper alignment. Note: Detail is
top view.
10
Install top Panel Clips.
•
Attach the clips as shown, using the provided
self-drilling screws.
•
One panel clip should be installed every 18-
24" for proper alignment.
REAR
SIDE
REAR
SIDE
REAR
SIDE
REAR
SIDE
Installed Panel
Panel Clip
TOP VIEW
Installed Panel
Panel Clip
Panel
Mounting
Extrusion
TOP VIEW
1" Spacer
End
Point
Mark
Mounting
Extrusion
11
Identify LightPlane Panel(s).
•
LightPlane Panels will arrive with attached
leads and quick connects zip tied on back side
of panels.
•
Cut zip ties and place leads on front of panel.
•
LEVELe LightPlane Panels are installed using
the same steps as LEVELe panels. LightPlane
Panels have an attached, visible power lead.
BACK VIEW
12
Install Panel Clips to side of panel.
•
Attach the clips as shown, using the provided
self-drilling screws.
•
One panel clip should be installed every
18-24" for proper alignment, but panel clips
should not obstruct wire exit locations, as
indicated on LightPlane Panels.
CAUTION
DO NOT OBSTRUCT
WIRE EXIT LOCATIONS
Installed
Panel
LightPlane
Panel
Panel
Clip
