3/7
3. Remove Galvo Block
Using a 2.5mm hex driver, remove the recessed screws in the upper right
and lower left corners of the galvo block. Once the screws are removed,
slowly wiggle the galvo block free from the Form 1+ frame.
WARNING: DO NOT REMOVE OR TAMPER WITH ANY OTHER SCREWS IN THE
GALVO BLOCK. ADJUSTING ANY OTHER SCREWS WILL MOVE THE PRINTER
OUT OF CALIBRATION.
Cut a strip about 1cm wide out of PEC-PAD. Lay the swab stick on the
PEC-PAD as shown above. Apply a piece of tape extending beyond the length
of the PEC-PAD strip.
DO NOT COPY OR REDISTRIBUTE THIS INFORMATION
4. Prepare the Swab
4. Prepare the Swab
