Emptying the Waste Bin
Shredded paper and particles accumulate in the shredder waste bin during normal operation. When the
“Waste Bin Full” lamp lights, empty the waste bin.
1. Switch the shredder off by pressing the STOP button on the control panel, turn the Key OFF/ON toggle
switch to the OFF position and flip the main power switch to the OFF position.
2. Open the waste bin door. Grasp handle on waste bin and pull straight out. Gather sides of shredder bag(s)
using drawstring and slide bag up and out. Empty and replace bag.
3. Push the waste bin in, close the door, turn power switches back on and resume shredding.
Maintenance and Inspection
9
Conveyor Belt Maintenance
•
Checking Belt Tension
When loaded with material, the conveyor belt must not slip, i.e. stand still when material is loaded. If the
belt slips, it must be tightened. Contact the Formax Service Department for assistance.
•
Checking Belt for Wear
The upper surface of the conveyor belt can become worn over time. The belt must be replaced when
the woven fabric inlay becomes visible. Contact the Formax Service Department for assistance.
•
Cleaning the Conveyor Belt area
The conveyor belt area must be cleaned once a month, or as needed to maintain optimal performance.
1. Switch off the shredder and unplug from wall outlet.
2. Remove the covers on both sides, revealing the cleaning openings in the conveyor belt area.
3. Use compressed air to blow out particles, or a vacuum to remove dirt and dust.
4. Re-install side covers.
NOTE: Paper clips in the shredded materials may increase the frequency of cleaning necessary, and may
become caught in the sides of the belt.
Removing & Reinstalling Side Covers
Side covers are attached by Phillips head screws.
1. To remove covers, insert screwdriver through access
holes (Fig. 1), and remove screws. Lift covers off
frame hooks.
2. To reinstall, rest panels on hooks, replace screws.
NOTE: The maintenance procedures which follow should be
performed only by authorized and trained technicians.
Figure 1