Operation
1. Flip the power switch “ON”, located on the right
side of the machine.
2. Slide open the safety shield on the top of the
cabinet (Fig. 1).
3. Insert a hard drive into the punching chamber
(Fig. 2). The chamber automatically adjusts for 2.5”
or 3.5” hard drives.
4. Slide the safety shield closed.
Set-up Guidelines
1. Install the FD 87HD on a level surface, away from heat sources and direct sunlight.
2. Insert plug into wall outlet with the appropriate voltage, 110V. If the outlet is shared
with another electronic device, the total current should not exceed 30A (at 110V).
Specifications
Safety Precautions
To avoid personal injury, and damage to the hard drive punch, observe the following
safety precautions. Please keep these instructions for future reference.
NOTE:
In case of emergency, flip the “Power Switch” to
cut off power and/or pull the plug out of the wall outlet.
•
Keep hands, long hair, clothing, ties, jewelry and loose items away from the
punching chamber.
•
Do not use the hard drive punch for anything other than its intended purpose.
•
Do not allow children to use the machine.
•
Do not operate with a damaged power cord or plug, or when the machine is
damaged in any manner.
•
Unplug the hard drive punch when it is being moved, or if it is not in use for an
extended period of time.
•
Do not disconnect the power by pulling only the cord. Hold the plug when
disconnecting.
•
Keep the machine away from direct sunlight.
•
Do not sit on the machine or place anything on top of it.
•
Never open the fixed switch or cover.
Fig. 1
Fig. 2
Punch Hole Size:
.39” (10mm)
Hard Drive Size:
2 1/2” or 3 1/2”
Feed Opening:
4.65” (118mm)
Punching Cycle:
14 seconds
Dimensions:
19.68” W x 18.5” D x 35” H (500 x 470 x 890mm)
Weight:
154 lbs. (70kg)
Security Level:
H-3 (DIN 66399 standard)
Power Supply:
110V, 50-60Hz
Fig. 3
5. Press the green START button on the
control panel (Fig. 3). The punchining
chamber will be illuminated by LED,
and the punching die will puncture the
hard drive. After a brief pause, the die
will reverse direction. Once this has
happened and the light goes out, the
process is complete.
6. Press the release button (Fig. 4) and the
punctured hard drive will drop into the waste bin
(Fig. 5).
7.
Auto Reverse
In case of a jam, the FD 87HD is designed to operate
in reverse, to protect the punching die.
8.
Door Open / Safety Shield Sensor
The control panel “Door Open” LED will indicate if
the door is open or if the safety shield is open. The
machine will not operate until both are closed.
9.
Waste Bin Full Sensor
If the waste bin is full, the “FULL” lamp will light and
the FD 87HD will stop automatically. Open the door,
empty the waste bin, replace the waste bin, close
door, and continue to punch.
Fig. 4
Fig. 5
