10. If necessary, readjust the position of the Feed
Roller Carriage so that the form starts to burst when the
perforation is just under the Tear Bar.
NOTE:
The Tear Points can be moved to allow the operator to
position them at any location along the Tear Bar. The
Tear Points should be set between the perforations
that run the length of the form. (Fig. 11)The Tear Bar
height is adjustable to accommodate the characteristics
of various forms. To adjust the height, the tear bar must
be pushed to compress the spring and lifted out. Then
rotate 180 degrees (turned over) and replace making
sure that the square end of the bar locks in the
brackets. Lower position is normal operation, #2313-up.
(Fig. 12)
11. Close safety cover. Machine is now ready to Burst.
Press start button and readjust machine speed to the
fastest, yet smoothest Burst.
8
