![background image](http://html1.mh-extra.com/html/formax/fd-1606-autoseal/fd-1606-autoseal_operators-manual_2320037020.webp)
16
DAILY MAINTENANCE
1. I
t is recommended to let forms cool for one-half hour after being removed from the laser printer, before processing.
This allows toner to set on the forms and static electricity to discharge. The FD 402 Jogger is recommended for best
results. The Jogger squares the forms and dissipates heat and static electricity created by laser printers.
2. Clean infeed tires and fold rollers with Formax recommended roller cleaner & rejuvenator to remove paper dust and
toner. A Formax Cleaner Kit is available from your dealer. A damp cloth with water is the best alternative.
CAUTION:
Do not use any chemicals other than the roller cleaner & rejuvenator or water.
Fig. 33
Fold Rollers
1.
Make sure machine is turned off and unplugged. All folder/sealers have three infeed tires, four rubber fold rollers
and two metal seal rollers (Fig. 33).
2. Remove the top cover and remove the upper and lower fold tables.
3. Using Formax roller cleaner, spray a new cotton cloth until the cloth is saturated. Wipe the wet cloth in a back and
forth motion making sure to clean the entire surface of the infeed tires, fold and seal rollers. Next, use a dry cloth to
wipe off excess toner. The cloth should be covered with black toner surplus from cleaning the rollers.
4. Run 10-15 sheets of blank copy paper to ensure all cleaner has been removed from the tires, fold and seal rollers.
Running blank sheets will remove any excess residue of cleaner on the rollers.
NOTE:
If the fold rollers are very dirty, you may use a green scrubbing sponge, i.e. Scotch Brite, with the roller cleaning
solution.
DO NOT
use a scrubbing sponge on the metal seal rollers. It will damage the surface. Use ONLY a new cotton cloth and
roller cleaning solution on the seal rollers (Fig. 33).
CLEANING PROCEDURES:
Infeed Tires
Seal rollers