Page 19
The calibration allows calibrate procedure as below:
On job #4 to hold
then
press
to set cutting mark,
C
ut a printed sheet with mark
.
M
ake
sure the leading edge of the mark to cutting line is 3mm
Select mark:50, if the cut mark leading edge to cutting line is greater or smaller than 3mm,
press
and
to adjust. Each press represents 0.1mm increment or decrement.
After adjust
ing
the mark value, press
to save the setting. Cut the mark again
.
I
f the cut mark is not
within spec. repeat the calibration.
