Page
29
/
62
7.4.1 Changing the position of the back gauge with the hand wheel
1. Press knob, 2
2. Turn the knob to move the gauge closer or farther away by reading the position value on the
touchscreen.
Figure 17. Changing the position of the back gauge
7.5 Using the paper clamp
Danger!
Do
not put your hands into the cutting area when clamping!
7.5.1 Clamping the material without cutting (determination of the cutting line)
Lower the paper clamp onto the stack by pressing the pedal, 2 (Fig.18). The front edge of the
clamping bar is the same as the cutting line. Therefore, it can be used as an indicator of the
cutting line. The clamp can be stopped in any position.