PAPER JAM (AUTO REVERSE FUNCTION)
If the jam is caused by too much paper being input, the following will happen:
Cutting blades will jam, then run in reverse for a short time and stop.
Motor will switch OFF
Control display
will light.
To remove the jam:
Remove the paper that has been fed back out.
The cutters will automatically run in the forward direction, shredding the remaining paper in the cutting
blades. During this time, the Forward LED will light. The control display will go out.
Continue shredding with smaller stacks of paper.
If necessary, switch the cutting blades manually alternately from forward to reverse until the material has
gone through completely and been shredded.
LIGHT BARRIER IS COVERED WHEN DOOR IS OPENED
If there is still material in the feed slot when the door is opened, the motor switches off and the cutting blades stop. The
control display will light.
Close the door and reset by pressing the Forward button briefly.
LIGHT BARRIER IS COVERED WHEN SHREDDER IS TURNED ON
If there is material in the feed slot when the paper shredder is turned on, the control display will light.
Remove the material in the feed slot and reset by pressing the Forward button briefly.
Malfunctions / Troubleshooting
Emptying Optical Media Waste Vacuum
The vacuum should be emptied periodically and/or
when the Bag Full LED is lit.
1. Turn OFF optical media power and main power
switch.
2. Open the door to access the vacuum.
3. Unplug the vacuum power cable and detach
both the suction and exhaust hoses from the
vacuum canister.
4. Remove the vacuum.
5. Carefully empty contents in proper receptacle.
6. Reverse the process to reinstall the vacuum.
Detach Side
exhaust hose
Detach suction hose here
Vacuum power plug
