4.
Install the out-feed panel (Fig 2), using five Button Head (short) screws and the Allen wrench supplied with unit.
Attach the side guide and backstop to the tray and then mount to the out-feed panel by sliding the tabs of the tray
into the slots on the panel, as shown in Fig 3. The tray sits at an angle to direct printed material to the backstop, it
can be raised or lowered to best stack the material being printed.
5.
Adjust the backstop up or down to best fit the media being printed. The tray extension can be pulled out for longer
material (Fig 4).
3
Fig 3
Fig 2
Button Head Screws
Side Guide
Out-feed Panel
Backstop
Tray Extension
Fig 4
Summary of Contents for CJ-10
Page 1: ...6 2017 OPERATION MANUAL Rev 3 CJ 10 FD 282 30 Conveyor Stacker CJ 15 1000 Watt Dryer...
Page 2: ......
Page 4: ......
Page 9: ......
