Start ......................... Starts machine.
Stop/ Reset............... Stops machine / clears “fault” condition.
Jog............................ Allows one piece of paper to feed at a time. Used for paper fold settings.
Power........................ Light comes on when power is on.
Cover open............... Light comes on if either top cover or side cover is open.
Paper out.................. Light comes on when infeed paper tray is empty.
Fault detect............... Light comes on if there is a paper jam.
Reset......................... Resets counter.
Counter..................... Shows forms count.
CONTROLS
OPERATION
1. Adjust fold plates to desired fold for length of paper ( see fold plate adjustment on page 3). To do this first
loosen two thumbscrews (figure 1a) on each fold plate. Align center bar (figure 1b) so the marks on each
side match up. For “V” folds remove the lower fold plate, turn around 180
O
and reinstall
2. Load neatly stacked and squared paper into the hopper. Paper can be stacked up to 200 for the FD 2000
and 250 for the FD 2030. Note: Standard “Z” fold forms can be loaded face up or down with the glue edge
leading. All “C” fold forms must be loaded face up with glue edge leading.
3. Make sure covers are closed properly.
4. Plug in cord and turn power on.
5. Press jog switch to make sure folds are correct, adjust if necessary (see fold plate adjustment pg 3).
6. Press the start button to begin operation.
2
