Formax AutoSeal FD 1506, Operator'S Manual

Page: 12 / 12

TROUBLESHOOTING
B. Fold Quality Needs Improving:
1. Make sure paper is squared and installed correctly. Side guides should be evenly balanced and
snug against the paper.
2. If folds are still incorrect adjust fold plates (see fold plate adjustment on page 3).
8
C. Paper is not Folding Square (Skewing):
Figure 9
1. If paper pulls left or right adjust the skew. Turn
the skew adjuster, located under the infeed tray,
(Fig. 9) left or right until the paper is feeding
correctly.
D. Machine plugged in, no power
1. Turn machine on.
2. Make sure top cover is installed properly.
3. Reset the breaker by pressing the black button (fig. 7) near the power cord inlet.
4. Check wall outlet.
5. Remove operator cover check the fuse located on control board next to transformer.
6. Check all electrical connections.
F. Double feeding / Mis-feeding
1. Clean feed wheel (soap and water)
a. Check center in-feed roller and singulator pad for wear. Replace the pad if it is cupped.
b. Check to see if center in-feed roller is centered on the gate tip.
2. Run a stack of plain paper, to check on proper feeding. If double feeding does not occur on the
paper:
a. Check to be sure pressure seal forms are not sticking together. Jogging or hand
separating may be necessary to determine this.
b. Hand separate about 50 forms, align and test run the forms. If no double feeding occurs
proper forms handling is necessary.