Install metal brackets
FormFit
Hood Protector
10
Start screws
N
O
T
E
N
O
T
E
Start a screw into each pedestal a few turns. The tip of the screw
must not protrude into the hole where the attachment pin will install
later.
Peel and fold the anti-abrasion film pads in half over the hood edge
between the fingers on each of the mounting pedestals.
Once locations for the remaining pedestals have been established,
repeat steps 3, 4 and 5 for those pedestals.
Place all pedestals carefully as once they are stuck
down, they are very difficult to remove.
Install anti-abrasion film
12
N
O
T
E
11
N
O
T
E
Push metal mounting brackets over the hood edge aligned with the
anti-abrasion pads. Ensure the bracket is fully seated over the hood
edge and the hole in the bracket is aligned with the hole in the
pedestal.
Attach remaining pedestals
9
HD 10M18
Rev0.May 11, 2018
page 6 of 9
