Remove the hood protector installation tape measure by loosening
the screw and removing the pin.
N
O
T
E
N
O
T
E
5
Remove the red backing from the adhesive and install on the hood
surface. Tip: Hook the fingers on the pedestal over the hood edge and
rotate the unit into position. After installation, remove the tape strips and
“wet out” the pedestal base by applying pressure with your thumb
around the surface of the pedestals.
Temporarily fit remaining pedestals
N
O
T
E
FormFit
Hood Protector
Permanently attach pedestal
6
7
Test fit hood protector
Remove installation tape measure
8
Dry fit the pedestals using tape strips supplied or masking
tape to temporarily hold them in position. The positions of the
pedestals are shown in the illustrations. Use the center line
on the leading edge of the pedestals for accurate measuring.
See illustration.
Important: “wetting out” of the pedestal will ensure
maximum adhesive bond.
• Place the hood protector on the pedestals to confirm proper
positioning.
• Ensure the holes in the protector align with those in the
pedestals.
• If necessary, reposition the pedestals so all attachment positions
are correct and the protector is well centered.
N
O
T
E
HD 10M18
Rev0.May 11, 2018
page 5 of 9
