INSTALLATION
• Make sure the vehicle is clean and completely dry before installation.
• This product uses a 3M adhesive that requires installation and curing temperatures of 15° to 43°C (60° to 110°F) for 1 hr to develop
maximum adhesion to the hood surface. Failure to install this product at the proper temperature or allow adequate curing time before use is
not covered under warranty.
• Proper installation of the adhesive pedestal system requires the use of a #2 Phillips screwdriver, preferably with a long shaft. The shaft of
the screwdriver needs to fit through the hole in the pedestal. Use of the correct screw driver will facilitate a trouble free installation. Do not
attempt to use #1 or smaller Phillips screwdriver or any type of electric screwdriver.
WARNING
Do not pull/push on the protector when opening/
closing the hood.
NOTE
On some vehicles it may be necessary to adjust the
hood bumpers and/or latch for proper clearance.
CARE
Hand clean the protector using a mild soap and water solution or plastic cleaner
only.
Avoid automatic car-wash equipment where a brush and/or soft cloth come in
contact with the hood protector. Touch-less style automatic car-wash equipment is
less likely to harm the hood protector.
SERVICE
Periodically check to confirm the protector is securely attached to the hood.
FormFit
Hood Protector
HD 10M18
Rev0.May 11, 2018
page 3 of 9
