Audio/Video
VibraSound, 3D sound, Speaker Placement
This unit has VibraSound with volume control (internally amplified speakers that
work with your salon’s music source). VibraSound units can be configured to
handle up to four music sources (Multi-Channel) with the addition of the optional
DMS music adaptor (see below). Contact your salesman for more information.
If a music source is to be used the audio installer must have the wiring in place
before delivery and must be present when the equipment is installed. Forever Tan
has to turn on this feature and adjust the input volume so that it will conform to the
volume of the source.
Important Information on the Multi-Channel System
If you want to use the channel selector in this unit there are three things that will be
required.
1.
A DMS Music adaptor. This will allow you to have up to four different
sources of audio. This unit can be purchased
from the Forever Tan
parts department.
2.
A standard 120-volt receptacle located behind the left side of the bed.
This is to plug in the DMS Music Adaptor.
3.
Audio source, this can be a Pre-amplifier, Power amplifier or 100 Volt
systems.
Speaker Placement
If you choose to use an external speaker the location to the center will be on the wall
to the right side of bed, 29” from back wall, 36” off the floor.
*Speaker placement was measured allowing 6 inches of clearance at the back of the
unit for electrical hook-up. You may use the equipment measurements provided to
draw a footprint of the unit on the floor of the room and determine where you want
the speaker.
Multivision has some special requirements and restrictions
please contact
Jeremy Welch
at
(704)971-4744
.
