TIMER WIRING INFORMATION
The cable required for the “
Single Station”
remote timers is a 4 conductor 24 AWG
flat cable commonly known as “Silver Satin”. It can be purchased from Forever
Tan Service Department.
The cable required for the CCS IV
“Back-Bone System”
is a 4 conductor 24 gauge
shielded cable. It can be purchased from Forever Tan Service Department.
The
“Back-Bone System”
is used when networking multiple beds to the Intellitan
CCS IV or T-Max Manager Pro main station timer. The
“Back-Bone System”
utilizes a single continuous run of 4 conductor 24 gauge shielded cable that starts in
a single-gang box near the mounting location of the CCS IV or T-Max Manager Pro
main station timer, from there it loops through (12 inches, uncut) single-gang boxes
in each room and terminates in a single-gang box in the last room. After the cable
has been pulled and looped through each box a 110 punch-down jack (AMP 41106-
RI6) is installed on the cable (using a punch-down style jack eliminates the need to
cut the cable). The jack is then mounted to the faceplate (AMP 41080-1IP) the
faceplate is then attached to the single-gang box. The jacks may be purchased from
Forever Tan Service Department for $3.00 each and the faceplates for $2.00 each.
Forever Tan Service Department will install the jacks and plates (at the time of
delivery of the units) for an additional $5.00 per room, provided that the cable and
the single-gang boxes have already been installed by you (the owner) or your
electrician PRIOR to the delivery of your tanning units. (See diagrams.).
IMPORTANT NOTE; The CCS IV or T-Max Manager Pro main station timer
requires a 120-volt outlet within 4 feet of where the timer will be mounted. This does
not have to be a dedicated circuit.
See individual diagrams for placement of outlet boxes.
IMPORTANT
Forever Tan does not do any pre-wiring or installing of timer wires. We recommend
having an electrician do this for you. The wire is available from the Forever Tan
Parts Department.
No employee of Forever Tan is allowed (either written or verbally) to include any
timer wiring with any purchase of tanning equipment from Forever Tan.
Forever Tan will (for additional charge) terminate the timer connections upon
delivery of the beds/equipment if the pre-wiring is complete.
