P| 8
ANGEL'S TRELLIS SWING
www.ForeverRedwood.com
NOTE:
In order to know where the post needs to be placed, check the numbers on them. If the post is not marked, then place
the single Supports on the ground to locate the markings for each post position and clearly set your bearings. (“Don´t attach yet,
only place them on the ground to begin with”).
Note:
Before install the anchor bases make sure that the ground is level using a carpenter's level or hydro-level (water level).
Step 1:
Install the anchor bases
(16)
with ½” x 3 ½” anchor bolts
(AB1)
. Please see the “How to anchor your pergola document”
for all details. Set your post
(1)
in the saddle of the anchor bases. Drill a ø ¼” hole in the post prior to anchoring to facilitate the
ratcheting of the hardware. After that, use 5/16” x 3” lag bolts
(LB1)
to attach each post to its respective anchor base
.
Step 2:
Use 3/8” x 6 ¾” bolts
(BL1)
to attach the simple support -A
(2)
to the posts
(1).
Check the marked numbers on each
single support and place as drawings shown.
Note:
Don’t completely tighten yet the bolts – you will need the install the supports with in between blocking first.
BL1
1
1
2
BL1
1
1
16
2
