PRE-DRILL
WITH 2MM BIT
FOR ALL STEPS
BELOW.
PRE-DRILL
WITH 2MM BIT
FOR ALL STEPS
BELOW.
PRE-DRILL
WITH 2MM BIT
FOR ALL STEPS
BELOW.
60
MM
SCREWS
60
MM
SCREWS
60
MM
SCREWS
60
MM
SCREWS
60
MM
SCREWS
5
1a
FLOOR & PANEL LAYOUT
1c
APEX SECTIONS
1b
SIDE PANELS
Position the floors
in your desired location.
Turn the floors upside down to
secure the
sections together
by screwing through the
adjoining bearers.
Layout the panels
around your shed base.
We recommend to start in a back corner then
work from the back panels to the front
panels for assembly.
Attach the first Apex Section
to one of the
side panels by screwing to the wall panels as
shown below.
Attach the other Apex Section
to the other
side panels by screwing to the wall panels as
shown below.
Start at a back corner.
See the section layout
on page 4 to confirm position. Secure the
corner as shown below.
Repeat the process for the remaining panels
and
secure
the
panels together.
Make sure
that the bottom frame of the wall panel rests
on the outer edge of the floor.
Secure the panels into place by
screwing into
the floor bearers.
Use 4 x screws for the larger
panels and 1 x screw for the smaller panels as
shown in the bottom visual.
EG. INSIDE CORNER
SIDE PANEL
BACK PANEL
EG. SIDE PANELS
APEX SECTION
EG. INTO FLOOR BEARERS
APEX SECTION
