OUTSIDE
INSIDE
15x12
Beading
Plastic
Z-Strip
Window
Sits onto
Z-Strip
PRE-DRILL
WITH 2MM BIT
FOR ALL STEPS
BELOW.
PRE-DRILL
WITH 2MM BIT
FOR ALL STEPS
BELOW.
BE CAREFUL NOT TO HIT
THE WINDOW WHEN
NAILING THE BEADING
INTO PLACE.
30
MM
NAILS
30
MM
NAILS
6
2a
WINDOWS, Z-STRIPS & BEADING
3a
COVER STRIPS & DOOR STRIPS
2b
INTERNAL WINDOW STRIPS
Place the Z-Strip into position.
Trim the
Z-Strip to the window opening measurement.
Position the Window onto the Z-Strip.
Place the 15x12mm Beading onto the Z-Strip
and up against the Window. Secure
in place
with 3 x nails per single window. (Use 2 x nails
per window for the front double window panel
if applicable).
Remove any protective film after the assembly
is complete.
Attach the Back Cover Strips
to the corners
and adjoining panels. Ensure they are flush to
the bottom edge of the panels.
Attach the Front Cover Strips
to front corners
and adjoining panels.
Attach the Side Cover
Strips
to the adjoining side panels. Ensure they
are flush to the bottom edge of the panels.
Secure the Door Weather Strips.
Ensure they
are in contact with the floor and against the
inside face of the wall panel frame.
Secure the Window into position by
sliding the
Top and Bottom Strips into the frame and
screwing in place.
Further secure by
sliding the Side Strips into
the frame and screwing in place.
Repeat the same process for the other
Windows.
Ensure all Windows are fixed into
place.
WINDOW
BEADING
Z-STRIP
INSIDE
OUTSIDE
TOP/BOTTOM WINDOW STRIPS
SIDE WINDOW STRIPS
WALL
PANEL
FRAME
DOOR
WEATHER
STRIP
BACK COVER STRIPS
FRONT & SIDE COVER STRIPS
DOOR WEATHER STRIPS
WINDOW POSITIONING