132mm
DOOR FIXINGS
4a
8
Fix the turn buttons and tower bolt
as shown below.
DOOR FACE
PIN IN LINE
WITH DOOR
FACE
DOOR
Make sure the outer
face of the notch on
the hinge is in line
with the door face.
PRE-DRILL
WITH 2MM BIT
FOR ALL STEPS
BELOW.
Attach 3 hinges onto the door frame.
Use
the measurement provided for positioning
of the bottom hinge. Please take note of the
hinge position shown below.
Place the door into the opening,
ensuring it’s level.
Make sure the hinges
are up against the door weather strip face.
5mm
Allow a 5mm gap at the
top when placing door.
HINGE POSITION
DOOR
COVER AND DOOR STRIPS
3
Secure the door weather strips.
Ensure
they’re flush to the floor and against the
inside face of the wall panel frame. Rest
and centralise the top strip onto the side
strips. Screw into place. All 3 strips will
overhang into the door way.
DOOR HINGE STRIPS
(45x12x1650mm)
COVER STRIPS (44x16x1583mm)
Attach the cover strips
onto
the corners. Ensuring they are
flush to the bottom edge of the
panels as shown below.
Attach the cover strips
onto the
adjoining panels. Ensuring it is
flush to the bottom edge of the
panels as shown below.
Secure the door hinge strips.
Ensure they’re in contact with the
door batten and against the door
weather strips.
SIDE WEATHER STRIPS
(50x12x1667mm)
OUTSIDE
OUTSIDE
INSIDE
INSIDE
PRE-DRILL
WITH 2MM BIT
FOR ALL STEPS
BELOW.
WALL
PANEL
FRAME
DOOR
WEATHER
STRIP
OUTSIDE
4b
Apply the kick plate strip and
canopy strip
as shown below.
Ensure to use the correct screw
size, shown next to the part.
Secure the slamming strips.
Position
using the measurements provided.
Screw the slamming strips onto the
opposite door that you have fixed the
tower bolt.
INSIDE
60mm
110mm
60mm
110mm
Fix the turn button and barrel bolts
as shown below. Ensure
the barrel bolts are on the same door you have attached the
slamming strips. Whereas the turn button is on the opposite
door.
DOOR
SLAMMING
STRIP
20mm
OVERHANG
INSIDE
GAP FROM FLOOR
GAP INBETWEEN
TOP WEATHER STRIP
(45x12x1198mm)
