ASSEMBLY INSTRUCTIONS
Make sure the power switch on the back of the control box is turned
OFF.
Check to
see that the voltage selector switch on the back of the control box is set to the
voltage to be used 110 or 220 volt. Then follow steps below:
1.
Connect the power cord into the back of the Control
Box and into a power outlet.
2
. To use the Foot Contol, plug the Foot Control cord into
the port on the back of the control box. Align the pins
carefully and tighten the locking ring.
3.
Plug the Handpiece cord into the port on the front of
the control box. Align the pins carefully and tighten
the locking ring.
4.
Set the Speed Dial to '0'.
5.
Make sure the handpiece collet is in the locked
position with a bur or accessory in it and that the
collet and accessory can spin freely.
Control
Box
Back
Foot
Control
Plug
T-Slot
Plugs
Power
Cord
Voltage
Selector
Switch
110 or
220 volt
On/Off
Power
Switch
Fuse
Compartment
FWD/
REV
Mode
Selector
Handpiece
Connection Plug
Handpiece
Holder
Digital
speed
display
x1000rpm
Speed Dial
Run
Selector
Hand or
Foot Mode
Selector
Control
Box
Front
!
SAFETY INSTRUCTIONS: A Micromotor Handpiece is a high speed
rotary power tool which can be dangerous and cause serious injury
if it is not used properly.
•
ALWAYS wear proper eye and face protection.
•
ONLY use accessories rated for speeds of 50,000 rpm
or higher when operating this micromotor.
•
ALWAYS
observe the man u fac tur er’s maximum
speed rat ing when us ing any accessory.
•
NEVER
use or continue to use any accessory which
appears to be damaged, loose, vibrating, bent, or out of
balance. Inspect each accessory for cracks or flaws
before use.
•
ALWAYS
insert the shank or arbor of an accessory
or mandrel into the collet or chuck of the hand
piece as far as possible in order to provide proper
support and close the collet or chuck se curely.
•
DO NOT
use accessories with shanks that are
less than 1
″
long.
•
NEVER
use excessive side pressures which may tend to
bend or break the shank or arbor of an ac ces so ry. Let the
speed of the accessory do the work.
•
DO NOT
stall the motor by jamming or using excessive
pressure on the mounted point, buff, wheel or ac ces so ry.
This can result in damage to the motor.
•
WEAR
a dust protector to prevent the inhalation of
harmful dust or debris from grinding, carving or other
operations per formed with this power tool.
•
NEVER
operate with a damaged power cord.
•
USE
a dust collector or filter hood to pull sawdust,
grinding dust, or other debris away from the work
area and the micromotor.
•
NEVER
wear open shoes or sandals. Use foot-wear that
is tough enough to protect your feet from falling tools.
•
ALWAYS
keep both hands and fingers away
from the cutting edge.
•
NEVER
cut or exert pressure, toward your hand
or any other part of your body.
•
DO NOT
wear loose fitting clothing or jewelry.
Loose clothing or jewelry can become entangled in the
tool. Do not wear items such as neckties, necklaces, or
bracelets when operating power tools. Secure or tie
back long hair.
•
NEVER operate without wearing eye pro tec tion.
NEVER turn on or start the Handpiece while
collet is in open (unlocked) position.
This can damage the handpiece.
Always operate
and store it with a bur or other accessory in the chuck
and with the chuck in the closed position.
DO NOT
operate the handpiece in the presence of any flammable
liquid or gas.
UNLOCKED
