•
Connect one end of the second
cable to the negative (–) terminal
of the booster battery and the
other end as far away from the
battery as possible to the engine
block or the engine mount of the
engine to be started
2
.
Do not
connect to the negative (–)
terminal of the flat battery.
•
Make sure that the jump leads are
clear of any moving parts.
To start the engine
•
Run the engine of the vehicle with
the booster battery at moderately
high speed.
•
Start the engine of the vehicle with
the flat battery.
•
Run both vehicles for a minimum
of 3 minutes before disconnecting
the leads.
WARNING
Do not switch on the headlamps
when disconnecting the cables.
The peak voltage could blow the
bulbs.
•
Disconnect the cables in the
reverse order.
CHANGING THE VEHICLE
BATTERY
Vehicles with a petrol
engine
If the battery has been disconnected
the vehicle may exhibit some unusual
driving characteristics for
approximately 8 km (5 miles) after
battery reconnection while the
engine management system realigns
itself with the engine.
122
Vehicle battery
Summary of Contents for Transit Connect
