5. Firmly press and release the “learn” or “smart” button. (The name and
color of the button may vary by manufacturer.)
Note:
There are 30 seconds in which to initiate Step 6.
6. Return to the vehicle and firmly
press, hold for two seconds and
release
the programmed HomeLink
威
button. Repeat the
press/hold/release
sequence again and, depending on the brand of the
garage door opener (or other rolling code equipped device), repeat this
sequence a third time to complete the programming.
HomeLink
威
should now activate your rolling code equipped device. To
program additional HomeLink
威
buttons begin with Step 1 in this section.
For questions or comments, please contact HomeLink
威
at
www.homelink.com
or
1–800–355–3515.
Gate Operator & Canadian Programming
During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLink
威
to accept the signal
from the hand-held transmitter.
After completing Step 1 outlined in
the
Programming
section, replace
Step 2 with the following:
Note:
If programming a garage door opener or gate operator, it is
advised to unplug the device during the “cycling” process to prevent
overheating.
•
Continue to press and hold the HomeLink
威
button (note Step 2 in the
Programming
section) while you press and release —
every two
seconds
(“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink
威
. The indicator light will
flash slowly and then rapidly after HomeLink
威
accepts the radio
frequency signal.
•
Proceed with Step 3 in the
Programming
section.
2009 Navigator
(nav)
Owners Guide, 1st Printing
USA
(fus)
Driver Controls
108
