1.
Press
START/STOP
to switch off your
vehicle.
2. Press the brake pedal and
START/STOP
to switch on your
vehicle.
3. Remove your foot from the brake pedal
and press
START/STOP
to switch off
your vehicle.
4. You can attempt to start the vehicle
by pressing the brake pedal and
START/STOP
, or press
START/STOP
without pressing the brake pedal.
Note:
Both methods re-enable the fuel
system.
JUMP STARTING THE VEHICLE
WARNINGS
Do not use fuel lines, engine valve
covers, windshield wiper arms, the
intake manifold, or hood latch as
ground points.
Use only adequately sized cables
with insulated clamps.
Preparing Your Vehicle
Note:
Attempting to push-start a vehicle
with an automatic transmission may cause
transmission damage.
Note:
Use only a 12-volt supply to start your
vehicle.
Note:
Do not disconnect the battery of the
disabled vehicle as this could damage the
vehicle's electrical system.
Park the booster vehicle close to the hood
of the disabled vehicle, making sure the
two vehicles do not touch.
Connecting the Jumper Cables
E235907
1.
Switch off all accessories.
2. Remove the red cap over the positive
(B) post of the disabled vehicle.
3. Connect the positive (+) jumper cable
to the positive (B) post of the disabled
vehicle.
4. Connect the other end of the positive
(+) cable to the positive terminal of the
booster vehicle battery.
5. Connect the negative (-) jumper cable
to the negative (A) post of the disabled
vehicle.
6. Connect the other end of the negative
(-) cable to the negative terminal of
the booster vehicle battery.
Grounding Stud Location
E229889
129
Ford GT (CGX) Canada/United States of America, enUSA, First Printing
Roadside Emergencies