FG6250P(E) - FG7750P(E) - FG9250P(E)
EN
Copyright © 2016
P a g e
|
12
www.fordpowerequipment.co.uk
6.3
Installing Support Leg (See Fig.3)
Parts needed - Support leg & M8 screw (2).
Raise the front end of the generator high
enough to gain access to the bottom of the
frame.
Securely position props underneath to
support.
Line up holes on the support leg bracket to
the holes on the front of the generator
frame.
Attach the support leg using M8 screws (2).
Installing the handles (See Fig.3)
Fig.3
6.4
Attaching the Battery Cable (See Fig.4)
(FG6250PE / FG7750PE/ FG 9250PE ONLY)
Parts needed - Black and
Red battery cable
The Red (+) Connector
should be attached to the
battery first.
Remove the screw from
the battery terminal.
Place the screw through
the eyelet and tighten the
screw and make sure the
terminal will not touch any
part of the frame.
Install the Red protection
boot.
Fig.4
Repeat these steps for the Black (-) Terminal.
WARNING! Be careful not to short across the terminals when installing. Shorting
the terminals together can cause sparks, damage to the battery or generator, or
even burns or explosions.
Cover the terminals with the rubber covers
When removing the battery for replacement: Remove the nut and bolt first from the negative (Black)
post, then from the positive (Red) post, being careful not to short across the terminals. Always
abide by the safety warnings provided with the battery. Remove the battery and dispose of it
according to your local and state regulations.
WARNING! Battery posts, terminals, and accessories contain lead and lead
compounds known to cause | cancer and reproductive harm.
Always wash hands after touching battery