Note:
Your vehicle will remain locked for
approximately three seconds. When the
delay period is over, you can open the doors
again, provided the passive key is within the
respective detection range.
Two short flashes of the direction
indicators confirms that all the doors and
the liftgate have been locked and that the
alarm has been armed.
Liftgate
Note:
The liftgate cannot be closed and
will reopen if the passive key is located
inside the luggage compartment with the
doors locked.
Note:
If a second valid passive key is
located within the liftgate detection range,
the liftgate can be closed.
Unlocking Your Vehicle
Pull an exterior door handle to unlock and
open the door. Make sure not to touch the
lock sensor area on the top of the handle.
One long flash of the direction indicators
confirms that all the doors and the liftgate
have been unlocked and that the alarm
has been disarmed.
Note:
When your vehicle remains locked
for longer than three days, the system will
enter an energy-saving mode. This is to
prevent the vehicle battery running out of
charge. When your vehicle is unlocked while
in this mode, the reaction time of the system
may be a little longer than normal. To exit
the energy-saving mode, unlock your
vehicle.
Note:
A valid passive key must be located
within the detection range of that door.
Unlocking Only the Driver Door
You can program the system so that only
the driver door is unlocked. See
If the unlocking function is reprogrammed
so that only the driver door is unlocked the
following will occur:
•
If the driver door is the first door
opened, all the other doors will remain
locked. All the other doors can be
unlocked from inside your vehicle by
pressing the unlock button. The other
doors can be unlocked individually by
pulling the interior door handle on the
respective door.
•
If the front passenger door is the first
door opened, all the doors will be
unlocked.
Disabled Passive Keys
Any keys left inside your vehicle interior
when it is locked will be disabled.
You cannot use a disabled key to switch
the ignition on or start the engine.
You must enable all passive keys again in
order to use them.
To enable all your passive keys, unlock your
vehicle using a passive key that has not
been disabled or the remote control
unlocking function.
All passive keys will then be enabled if you
switch the ignition on or you start your
vehicle with a valid key.
46
Edge (CDQ, CWB) Vehicles Built From: 07-12-2015, GT4J 19A321 AKA enGBR, First Printing
Locks
Summary of Contents for Edge 2016
