GENERAL INFORMATION ON
RADIO FREQUENCIES
Note:
Changes or modifications not
expressly approved by the party responsible
for compliance could void the user’s
authority to operate the equipment.
The typical operating range for your
transmitter is approximately 33 ft (10 m).
A decrease in operating range could be
caused by:
•
weather conditions
•
nearby radio towers
•
structures around your vehicle
•
other vehicles parked next to your
vehicle.
The radio frequency used by your remote
control can also be used by other short
distance radio transmissions (e.g. amateur
radios, medical equipment, wireless
headphones, remote controls and alarm
systems). If the frequencies are jammed,
you will not be able to use your remote
control. You can lock and unlock the doors
with the key.
Note:
Make sure your vehicle is locked
before leaving it unattended.
Note:
If you are in range, the remote control
will operate if you press any button
unintentionally.
Note:
The remote control contains sensitive
electrical components. Exposure to moisture
or impact may cause permanent damage.
REMOTE CONTROL
You can program a maximum of eight
remote controls to your vehicle. This
includes any that were supplied with your
vehicle. The remote controls must remain
inside your vehicle during the programming
procedure. Fasten the front safety belts
and close all doors to make sure that
conflicting chimes do not sound during
programming.
Programming a New Remote
Control
1.
Turn the ignition key from position 0 to
position II four times within six seconds.
2. Turn the ignition to position 0. A tone
sounds to indicate that it is now
possible to program a remote control.
3. Press any button on a new remote
control within 10 seconds. A tone will
sound as confirmation.
4. Repeat step three within 10 seconds
for each new remote control. Do not
remove the key from the ignition when
pressing the button on the remote
control.
5. Switch the ignition back on (position
II) or wait for 10 seconds without
programming another remote control
to end the key programming. Only the
remote controls which you have just
programmed are now able to lock and
unlock your vehicle.
Reprogramming the Unlocking
Function
Note:
When you press the unlock button
either all the doors are unlocked or only the
driver’s door and the liftgate are unlocked.
Pressing the unlock button again unlocks
all the doors.
31
Ranger (TKE) Vehicles Built From: 01-10-2014, DB39120609AD (CG3575en) enGBR, Edition date: 09/2014, First Printing
Keys and Remote Controls