The remote entry system allows you
to lock or unlock all vehicle doors
without a key.
Note:
The lock and unlock features
work when the ignition is in any
position. The panic feature is active
when the ignition is in either the
accessory, off or on positions.
If there are problems with the
remote entry system, make sure to
take
ALL remote entry transmitters
with you to the authorized dealer
in order to aid in troubleshooting the problem.
Note
: If the vehicle is equipped with the E-Guard Cargo Protection
System™ the remote transmitter Unlock command will only unlock the
front doors; the only way to unlock the side or rear cargo doors from
outside the vehicle is with the key.
Two step door unlocking
1. Press
and release to unlock the driver’s door.
Note:
The interior
lamps will illuminate if the control on the overhead lamp is
not
set to
the
off
position.
2. Press
and release again within three seconds to unlock the
passenger doors and the rear cargo doors.
The battery saver feature will turn off the interior lamp 10 minutes after
the ignition is turned to the off position.
One step door unlocking
If the one step door unlocking feature is activated, press
and release
once to unlock the passenger doors and the rear cargo doors.
Note:
The
interior lamps will illuminate (refer to the
Illuminated entry
feature
later in this section), if the control on the overhead lamp is
not
set to
the
off
position.
Switching from two step to one step door unlocking
Your vehicle comes with two step unlocking enabled. With the vehicle
locked, unlocking can be switched between two step and one step door
unlocking by pressing and holding both the
and
buttons
simultaneously on the remote entry transmitter for approximately four
seconds and release. The park lamps will flash twice to indicate that the
Locks and Security
78
2010 Econoline
(eco)
Owners Guide, 1st Printing
USA
(fus)
