3. Simultaneously press and hold
both the HomeLink
威
and hand-held
transmitter button.
Do not release
the buttons until Step 4 has
been completed.
Some entry gates and garage door
openers may require you to replace
Step 3 with procedures noted in the
“Gate Operator and Canadian Programming” in this section for Canadian
residents.
4. The indicator light will flash slowly and then rapidly. Release both
buttons when the indicator light flashes rapidly. (The rapid flashing light
indicates acceptance of the hand-held transmitters’ radio frequency
signals.)
5. Press and hold the just-trained HomeLink
威
button and observe the
indicator light. If the light is constant, programming is complete and your
device should activate when the HomeLink
威
button is pressed and
released.
Note:
To program the remaining two HomeLink
威
buttons,
begin with Step 2 in the “Programming” section —
do not
repeat Step 1.
Note:
If the indicator light blinks rapidly for two seconds and then turns
to a continuous red, proceed with Steps 6 through 8 to complete
programming of a rolling code equipped device.
6. At the garage door opener receiver (motor-head unit) in the garage,
locate the “learn” or “smart” button (usually near where the hanging
antenna wire is attached to the unit).
7. Press and release the “learn” or “smart” button. (The name and color
of the button may vary by manufacturer.)
Note:
There are 30 seconds in which to initiate Step 8.
8. Return to the vehicle and firmly press, hold for two seconds and
release the HomeLink
威
button. Repeat the press/hold/release sequence
again, and, depending on the brand of the garage door opener (or other
rolling code equipped device), repeat this sequence a third time to
complete the programming.
HomeLink
威
should now activate your rolling code equipped device. To
program additional HomeLink
威
buttons begin with Step 2 in the
“Programming” section. For questions or comments, please contact
HomeLink at
www.homelink.com
or
1–800–355–3515.
2006 F-150 (f12)
Owners Guide (post-2002-fmt)
USA (fus)
Driver Controls
80
Summary of Contents for 2006 F-150
