Diagram 2: Wire Splicing and Connections
Wire Tap
Wire Splicing
For best results when connecting electric
fence wire, polywire or polytape, only use
the following methods to protect your
fence wire from corrosion and increase
the reliability of full power being distributed
to the rest of your electric fence.
Wire Connections
Split Bolt
When joining fence wire anywhere on the
Sleeve
fence, be sure to use B Figure 8 or Reef Knot.
Wire Joints
See Below.
Figure 8 Knot
Step 1
Reef Knot
Step 2
Knotting Polytape
Knotting Polywire
When knotting polywire, be sure to double
the ends of the connecting fence wire.
Then tie a Slip Knot, as shown below.
Pull Wire
to Tighten
To connect polytape, first start with a
standard knot. Be sure to leave between
3-4” of extra tape. Peel back around 2.5”
of the tape, exposing the conductive wires.
Twist the two wires together to make the
connection complete.
ENERGISER INSTALLATION continued. Page 9
Step 4 continued
Properly connect the hook-up wire from the energiser to the fence line(s) using
appropriate connection methods to ensure a good connection.
Joints along the fence line also need to be well made to ensure a good electrical
connection. Some common methods are shown in diagram 2 below.
There are two power options for your dual power AC/DC energiser:
Mains or 12V battery. They both plug into the same socket on the energiser..
●
100 - 240VAC mains
If you have access to a mains power socket,
then use your AC adapter (Separate Supply Unit)
to power your energiser.
●
12V battery
If you don't have access to mains
or using out-doors, then use the
battery clamp wire assembly to
connect to a 12V rechargeable
battery to power your energiser.
Step 5: Connect Power
R O
O
N
O
L
D
Y
NI
K
Y
E
R
E
D
P
(different plug types supplied for different regions)
●
Only use 12V rechargeable battery if powered by an external battery.
●
Do not attempt to recharge a non-rechargeable battery.
●
When charging the battery, ensure it is in a well ventilated area.
WARNING
Summary of Contents for DUALGIZER DG1
Page 2: ...Blank page...
