FORCE1 RC
12
PAIR TRANSMITTER WITH THE DRONE
1. Press the red button on top left of the transmitter while turning on
the power. The transmitter will emit one beep, and the green light
will start flashing. This indicates that the transmitter is in connection
mode.
2. While the transmitter is in connection mode, insert the drone battery
to power on the drone (see “Battery Installation” on page 9). The
transmitter will send out a long beep sound and the indicator light
will turn solid green, indicating that the drone is paired.
DRONE CALIBRATION
To calibrate the drone, Push both control sticks down and to the right (Fig. 11) – drone lights will flash
when calibration is successful.
FIGURE 6
FIGURE 11
CALIBRATION CONTINUED...
LOCKING AND UNLOCKING THE DRONE
NOTE
The left stick (throttle) must be pushed to the bottom position when pressing the red lock button.
Otherwise, the drone won’t lock or unlock.
Your drone may be locked or unlocked when you open it. Lock/Unlock
is a safety feature that prevents unintentional motor starts.
TO UNLOCK
Your drone is locked when the front lights are on and the back lights
are off. Push the left stick (throttle) to the bottom position, while
pressing the red button (Fig. 7). Listen for a long beep, and check
that the drone’s back lights also come on. The drone is unlocked
when the propellers start to rotate.
TO LOCK
Pull the left stick down to the bottom position while pressing and
holding
the red button (Fig. 7). The transmitter will beep, the
propellers stop rotating and the rear lights go off.
FIGURE 7
