Force America ONE SSC5100ex, Quick Start Manual

Page: 11 / 20

FORCE America ONE
TM
Quick Start Manual
Applying Material
7
Applying Material
When your FORCE America ONE
TM
system arrives from the factory it will be ready to apply
granular material in manual mode. When the system starts up, it will be in Standby, as shown in
Figure 7. Standby deactivates all outputs.
Each rotary adjustment knob on the Spreader Control / Operator Interface performs a different
function when applying material. See the table below.
Input
Input Function
Green On /
Standby Knob
Twist Left Decrease the auger set rate.
Twist Right Increase the auger set rate.
Pushbutton
Place the system in standby.
Remove the system from standby.
Blue Blast
Knob
Twist Left Decrease the spinner set rate.
Twist Right Increase the spinner set rate.
Pushbutton
Blast granular material.
Cancel Blast.
To spread granular material in manual mode:
STEP 1: Twist the On / Standby knob to adjust your granular output percentage.
STEP 2: Twist the Blast knob to adjust your spinner set rate.
STEP 3: Press the On / Standby knob to remove the spreader control from standby.
Granular material will spread regardless of whether the vehicle is moving or not.
STEP 4: Press the On / Standby knob to place the spreader control back in standby and
stop the outputs.
To spread granular and prewet material in manual mode:
STEP 1:
Press the top half of the switch labeled “Prewet” above the screen to enable
prewet liquid application. The switch
’s ON text will turn green when activated.
STEP 2: Twist the On / Standby knob to adjust your granular output percentage.
STEP 3: Twist the Blast knob to adjust your spinner set rate.
STEP 4: Press the button labeled Menu in the lower right-hand corner of the screen to
enter the Main menu.
STEP 5: Press the button labeled Material to enter the Material menu.
STEP 6: Press the button labeled Prewet Rate to access the prewet set rate.
STEP 7: Press the left and right arrow buttons to adjust your prewet output percentage.
When used with the optional remotes the gray knob can be twisted left and right
to decrease and increase the prewet output percentage.
STEP 8: Press the Ok button to save the setting and return to the Material menu.
To reduce the risk of death or injury, ensure
that all personnel are clear from moving
machinery before activating outputs.