Force USA F-HPR, Owner'S Manual

Page: 7 / 17

7
ASSEMBLY DIAGRAM 4
REMEMBER: Only hand tighten all nuts and bolts until whole F-HPR is assembled
1. Attach THE BASE FRAME (9) to the REAR BASE FRAME (8) using a BRACKET 110X45X3 (23), two HEX BOLT M10X65 (41),
four WASHER10 (49) and two AIRCRAFT NUT M10 (48)
2. Position the WEIGHT GLIDE POST (10) behind the BASE FRAME (9) and attach using a BRACKET 80X45X3 (24). In the
upper hole use a HEX BOLT M10X65 (41), two WASHER10 (49) and an AIRCRAFT NUT M10 (48). In the lower hole use a
HEX BOLT M10X60 (43) and a WASHER10 (49)
3. Attach a SLEEVE (35) to each end the SLIDING WEIGHT POST (21)
Skip this step if already pre-assembled)
4. Slide the SLIDING WEIGHT POST (21) down onto the WEIGHT GLIDE POST (10), with the posts orientated to the rear.
5. Attach an END CAP (32) to the end of each post and clip a SPRING CLIP (30) onto each post.
6. Align the REAR UPPER FRAME (11) with the top of the WEIGHT GLIDE POST (10) and attach using a BRACKET 80X45X3
(24). In the upper hole use a HEX BOLT M10X60 (43) and a WASHER10 (49). In the lower hole use a HEX BOLT M10X65
(41), two WASHER10 (49) and an AIRCRAFT NUT M10 (48)
7. Attach the REAR UPPER FRAME (11) to the REAR TOP BEAM (7) using a BRACKET 110X45X3 (23), two HEX BOLT M10X65
(41), four WASHER10 (49) and two AIRCRAFT NUT M10 (48)