Force USA F-HPR, Owner'S Manual

Page: 8 / 17

8
ASSEMBLY DIAGRAM 5
REMEMBER: Only hand tighten all nuts and bolts until whole F-HPR is assembled
1. Position the stoppered end of the CABLE (26) at the front end of the REAR UPPER FRAME (11) and draw the cable up
into the bracket.
2. Align a PULLEY (31) into the bracket so the cable runs over the top. Attach with a HEX BOLT M10X45 (44), two
WASHER10 (49) and an AIRCRAFT NUT M10 (48).
3. Draw the CABLE (26) through the socket above the REAR TOP BEAM (7) and up into the bracket behind it.
4. Align a PULLEY (31) into the bracket so the cable runs over the top. Attach using a HEX BOLT M10X45 (44), two
WASHER10 (49) and an AIRCRAFT NUT M10 (48).
5. Position a PULLEY (31) between the DOUBLE FLOATING PULLEY BRACKETS (25) through the individual holes at one end.
Attach using a HEX BOLT M10X45 (44), two WASHER10 (49) and an AIRCRAFT NUT M10 (48).
6. Draw the CABLE (26) down and under the floating pulley. Leave the pulley hanging at present.
7. Draw the cable through the socket at the top of the WEIGHT GLIDE POST (10). Position a PULLEY (31) in the socket so
the cable runs over the top of the pulley. Attach with a HEX BOLT M10X60 (43) and two PULLEY BUSHINGS (39).
8. Draw the cable down the rear of the WEIGHT GLIDE POST (10) and attach the end to the hole at the SLIDING WEIGHT
POST (21) using HEX BOLT M10X25 (47), two WASHER10 (49) and an AIRCRAFT NUT (48).
9. Attach a GRIP (38) to each end of the LAT BAR (19) (
Skip this step if already pre-assembled)
10. Clip the LAT BAR (19) to a HOOK (29). Connect the hook to the SHORT CHAIN (28). Attach a HOOK (29) to the other end
of the chain and clip the hook onto the front end of the CABLE (26).