figure 3 – mounted stand legs showing correct layout of the 3 rubber feet (yellow arrows)
rear leg
Once the device stand mounted, you may open the larger hard plastic container housing the
sigma.7 haptic device base.
First release the cables from the front packaging foam block before removing the system from
the box, as shown in figure 4.
figure 4 – box containing sigma.7 device, after removal of front foam part
Remove the pole attachment interface and power supply before lifting out device from its lower
foam block as illustrated in figure 5. While a first person may hold the device, a second person
may remove the lower foam block and place it on a table top or any other stable flat surface. The
device can then be installed back on this lower foam block, in its initial position, as shown in
figure 6.
pole interface
9
