Installation Guide
SPARC/CPU-5TE
Page 4
FORCE COMPUTERS
1.3
Before Powering Up
Before powering up, please make sure that the default switch settings are all set according to
the table below. Check these switch settings before powering up the SPARC CPU-5TE
because the board is configured for power up according to these default settings. For the
position of the switches on the board, please see the diagrams on the previous two pages.
1.3.1
Default Switch Settings
Table 1: Default Switch Settings
Diagram of Switch
Switches
Default
Setting
Function
SWITCH 4
SW4-1
OFF
reserved, must be
OFF
.
SW4-2
ON
reserved, must be
ON
.
SWITCH 5
SW5-1
OFF
Test Switch, must be
OFF
SW5-2
ON
Test Switch, must be
ON
SW5-3
OFF
SCSI Termination for SCSI # 2 on P2
OFF = Enable, ON = Disable
SW5-4
ON
SCSI Termination for SCSI # 1 on P2
OFF = Enable, ON = Disable
SWITCH 6
SW6-1
ON
Reset Key Control
ON=Reset Key enable, OFF=Reset Key disable
SW6-2
ON
Abort Key Control
ON=Abort Key enable, OFF=Abort Key disable
ON
1
2
ON
1
2
3
4
ON
1
2
