6
3520 Industrial Way • Jasper, AL 35501 • www.fifthwheel.com • 800-874-9780 • Email: [email protected]
NOTE:
If blocking kit is being installed on sliding mount you must install extensions and bracket guides on rear of
bracket as shown in Figures 17 through 20.
NOTE: Weld Extension Block As Shown in Figure 17. Grind Extension block weld flush with bottom side of bracket.
12. Install Bracket Guides as shown in Figure 18. Make sure bracket guide is 5/8" away from outside edge of slide
bracket as shown in Figure 19.
NOTE:
Do not weld on outside edge of guide. A weld in this location will cause interference with slide rail.
13. Tack shaft supports onto lower mount on all four sides making sure shaft will slide after each tack. Tap shaft
supports with a hammer until shaft will slide easily. Weld shaft supports to plate mount using a 3/16" minimum
fillet weld on all four sides as shown in Figures 19 and 20.
14. Assemble the provided washer and cotter pin onto shaft as pictured in Figure 16 (previous page).
15. Lubricate the entire length of the shaft with Never Seize before first use.
FIGURE 17
Weld Extension
Block Here
Slide Bracket Extension
FIGURE 18
Bracket
Guide
Extension Block
Slide Bracket Extension
Weld Pattern For Shaft Supports
Weld Pattern For Shaft Supports
5/8"
Weld Extension Blocks Here
Shaft
Support
FIGURE 19
Weld Extension Blocks Here
FIGURE 20
END OF PROCEDURE
