www.fonicainternational.com
www.fonicainternational.com
FLAG
ISODYNAMIC SPEAKERS
15
14
FLAG
ISODYNAMIC SPEAKERS
Make sure the
bend point
should be perfectly on top. Also, make sure the bars are anchored
to the panel frame by trying to extract them and pull without turning them. If they have not
been inserted correctly, they will slip off. Do not proceed further until the bars are perfectly
hooked, or the final position of the speaker would be dangerously unstable.
Remove the base from the packaging and turn it so that the side with the two holes is facing
down. The countersink of the holes needs to be at the opposite side to the bar.
Insert the two
supplied M8 screws
into the two holes of the base and screw them with the hex key to the
mounted bars on the panel.
Make sure the screws are tighten
, as they will be responsible of
the entire system stability.
Lift the device by holding it from the base and from the aluminum profiles and
place it on the floor in the right position.
STEP 6
CAUTION!
For absolute safety in using the speakers, use the supplied
double-sided adhesive feet, applying them making them
adhere to the bottom of the base and, after that, to the
previously cleaned floor surface. The adhesive does not
damage the surface of the floor. The surface must be clean,
solid and smooth. Do not apply them on a dirty, uneven,
crumbly or unsuitable surface such as carpets, rugs. The
use of the speaker with other supports can lead to product
instability and cause damages.