Follett horizon elite HCC1010A/W, Operation And Service Manual

Page: 4 / 44

4 HCC1010A/W, HCD1010A/W, HCC1410A/W, HCD1410A/W
Specifications
Electrical
Each ice machine requires its own separate circuit with electrical disconnect within 10 ft (6m).
Equipment ground required.
Standard electrical:
§ HCC1010: 208-230/60/1 (6 ft (2m) NEMA 6-15 cord and plug provided)
§
HCD1410: 208-230/60/1 (6 ft (2m) NEMA 6-20 cord and plug provided)
§
Amperage: 1010A/W - 11A,
1410A/W - 14A
Plumbing
WARNING
This equipment to be installed with adequate backflow protection to comply with applicable federal, state,
and local codes.
§
3/8" OD push-in water inlet (connection inside machine) - 3/8" OD tubing required
§
3/4" MPT drain
§ 1/4" FPT condenser inlet (water-cooled condenser only)
§ 1/4" FPT condenser drain (water-cooled condenser only)
Notes:
§
3/4" non-vented drain line must slope a minimum of 1/4" per foot (6 mm per 30.4 cm run).
§
Drain to be hard piped and insulated.
§ Separate drains for ice machine and condenser.
§ Water shut-off recommended within 10 feet (3m).
§ Water supply must have particle filtration. Follett recommends the filter system that has integral scale inhibitors.
(Follett item# 00130286).
§
Follett does not recommend the use of water softeners or bowl scale inhibitors.
Ambient
Air temperature 100 F/38 C max. 50 F/10 C min.
Water temperature 90 F/32 C max. 45 F/7 C min.
Water pressure – potable 70 psi max. (483 kPa) 10 psi min. (89 kPa)
Note: Water-cooled condenser pressure 150 psi (1034 kPa) max.
Heat rejection
1010 1410
Air-cooled 11,300 BTU/hr 16,000 BTU/hr
Water-cooled 12,800 BTU/hr 16,400 BTU/hr