2021
Before using any operation with the remote control, Insert 2 x AAA batteries to the back of the remote control.
If the product without downlights function, press the “Downlights” button on the remote control is invalid.
The remote control will not respond until the digital display is illuminated as it is in sleep mode.Before operating , press any
button once to illuminate the digital display in order to activate the remote control.
Do not press the remote control buttons more than once within two seconds for correct operation.Please wait for the receiver
to respond to the transmitter
NOTE:
NOTE:
STEP 1
: Plug in and turn the mains power supply on.
STEP 2:
Turn the
switch on the right hand side of the heater outlet to
“
I
”
position.
STEP 3:
Press the button to turn on the appliance.
STEP 4:
Press the
button once to activate the low heat setting , press it again to activate the high setting,
press it a third time to switch the heat setting off.
STEP 5 :
To change the flame brightness , press the
button to cycle through the brightness options.Turn
off the LED flame effect by pressing the button repeatedly until the flame effect cycles off.
STEP 6:
Activate the standby mode by pressling the button again.
STEP 7:
Switch the fire off by turning the
switch on the right hand side of the heater to the
“
0
”
position.
STEP 1
: Switch on the appliance using the switch.
STEP 2:
Press the power button on the remote control; the LCD display will illuminate.
STEP 3:
Press
“FLAME”
button on the remote control to select the desired flame brightness; there are 3 different
brightness levels available.
STEP 4:
Select the desired heat output by pressing the relevant heat setting button:
To activate the low heat setting, press
“HEAT l” ;
press it again to turn it off.
To activate the low heat setting, press
“HEAT ll” ;
press it again to turn it off.
The day and time can only be set using the remote control.
STEP 1
:Press the
“ DATE TIME”
button on the remote control , the day of the week will flash, Use the up and down
Setting the Current Day and Time
Remote Control Operation
Manual Operation
DOWN
LIGHT
LED Display
Up Selection
Down Selection
Open Window/Door detection
Heat II
Heat I
“-” Selection
“+” Selection
Downlights
Flame Effect
Timer ON/OFF
Fire ON/OFF
Timer Set
Date Time Setting
Clear button
buttons to
set the day of the week.Once the current day is set , press the “
DATE TIME
” button to confirm the current day.
STEP 2:
The hour setting will then flash once the day has been selected .Use“
+
”or “
-
” to adjust the time until the current
hour is selected.Press the “
DATE TIME
” button to confirm the current hour.
STEP 3:
Then the minute setting will flash once the hour has been set.Use“
+
”or “
-
” to adjust the time until the current minute is
set correctly.Press the “
DATE TIME
” button to confirm the current minute.
