I
GD
• use the heater to dry clothes
• site/use in an outdoor location(s)
It is important that the following clearances are maintained from the appliance to combustible materials. These clearances are
dependent on the securing location as defined below:
• The minimum distance to the front of the appliance is 900mm.
• There are no clearances for above or to the side of the appliance, apart from being clear of curtains and drapes.
Caution:This appliance is heavy.Always seek assistance whilst unpacking and/or during installation. Please read
all the instructions before continuing to unpack or install appliance.
Before starting the installation of this fireplace, please read the following:
I . The installation should be carried out by two adults to avoid injury or damage. If for any reason it is considered too heavy,
please obtain assistance.
2.When lifting the electric suite, always keep your back straight. Bend your legs and not your back. Avoid twisting at the
waist. It is better to reposition your feet.
3.Avoid upper body
I
top heavy bending. Always bend from the knees rather than the waist. Do not lean forward or sideways
while handling the heater.
4.Always grip the heater with the palm of the hand. Do not use the tips of fingers for support.
5.Always keep the hea ter as close to the body as possible. This will minimize the cantilever action.
6. Use gloves to provide additional grip.
7.Unpack the package and lift the product gently out of the box, put it on a flat surface with the front panel facing forward.
IMPORTANT - PLEASE READ COMPLETELY TH ROUGH THE INSTRUCTIONSANDVERIFYTHAT ALL LISTED
PARTS ARE PRESENT BEFORE ASSEMBLY.
CAUTION: DO NOT CONNECTTHE APPLIANCE TO THE
ELECTRICAL SUPPLY AT THIS TIM E.
Focal Point Fires Ltd assumes absolutely no responsibility for injuries and damages
that may occur due to improper installation or handling.
Remove any protective film coatings from the finished/decorative surfaces of the
appliance, if any. After having selected the final position of the appliance taking into
account the integrity of the wall the electric suite may be secured to the wall.
To ensure customer safety, be sure to design the installation so that the strength of
both the wall and any wall fixings used are sufficient. The appliance should not be
installed until all wet plastering and/or dry wall sanding and wall painting has been
completed. Do not block the ventilation holes of the appliance. The wall onto
which the appliance is installed must be flat. Install only on a vertical surface. Avoid
sloped surfaces. Installation onto anything other than a vertical wall may result in
fire, damage or injury.
If the appliance is to be mounted on the inner leaf of a conventional cavity brick
wall, or a solid wall, then the wall plugs and fixing screws provided may be used.
Depending on the condition of the wall it may be necessary to use additional fixings.
In this situation, any additional fixings and wall plugs should be of the same size and
type as the ones provided.
If the appliance is to be mounted on a dry lined wall or a timber framed construction wall then efforts should be made to fix
one position vertically, into one of the wooden studs, or supporting wooden members of the wall using the fixing screws
provided. If this is not achievable then the wall should be strengthened using appropriate building materials.
Installing the appliance.
Ensure the floor and wall are flat before
:::::::::::::========--
_._..-r-....
Jxl2mm screws
installation.
I .Attach a securing bracket to the back of
each edge of the surround as shown using
the 3 x 16mm screws provided.
Pre-drill the holes, using a 2mm diameter drill
bit to prevent the wood from splitting.
Repeat this for the other side of the appliance,
so that you have I bracket on the left and I on
the right of the appliance.
2. Careful!� place the appliance against the wall
and mark the holes of the brackets on either
side.
CI)
© 2021 Focal Point Fires Ltd.
